An outdoor swim spa has to earn its place on a hotel terrace or a villa garden. It is used for morning laps, guest hydrotherapy and evening relaxation, and it sits outdoors all year. That is why the model you select matters more than the category as a whole. This guide walks through the Outdoor Swim Spa WS-130Aⅲ as a worked example, and shows which decisions a buyer or project consultant needs to settle before the unit is ordered.
Start with the site plan, not the specification sheet
The first constraint on any swim spa installation is the envelope. The WS-130Aⅲ is listed in our catalogue at 8000 × 3000 × 1400 mm, which means an eight-metre run of clear floor with a three-metre width and space around it for access, plant and maintenance. On a villa terrace that footprint usually decides whether the unit sits on a slab, a podium deck or a ground-level garden pad. On a hotel project it decides whether the spa belongs on the pool deck, a rooftop terrace or a private villa suite.
Compare the neighbouring models in the same range before you commit. The Outdoor Swim Spa WS-125Aⅲ is listed at 5500 × 2300 × 1350 mm, so it fits a much tighter terrace. The WS-130Bⅲ runs to 9950 × 3000 × 1430 mm, and the WS-130Cⅲ to 11830 × 3000 × 1430 mm. If the site cannot carry an eight-metre span, a shorter model is the honest answer rather than a modification request.
Where the space is irregular — a curved terrace edge, an internal courtyard, a spa room rather than an outdoor pad — our customisable outdoor spa line supports square, round, oval and curved shell shapes instead of a fixed rectangular cabinet.
What the WS-130Aⅲ specification actually covers
The catalogue record for this model lists the following configuration. Treat it as the baseline for your enquiry, and confirm each line against the drawing set you approve.
| Item | Catalogue entry |
|---|---|
| Model | WS-130Aⅲ |
| Dimensions | 8000 × 3000 × 1400 mm |
| Control system | 1 set |
| Swim training system | 1 set |
| Water pump | 1 pc |
| Filter pump | 1 pc |
| Jets | 20 pcs |
| LED lights | 7 |
| Total power | 10.85 kW |
| Features shown | Water jets, LED lighting, Ozone, Swim training system |
Two of those lines drive the whole project. The swim training system is what separates a swim spa from a hot tub: it produces the counter-current flow that makes lap swimming possible in an eight-metre shell, which is the reason hotels specify this format for fitness-oriented guests and villas specify it for daily exercise. The 10.85 kW total power figure is the electrical load you must coordinate with the building services team, together with the supply arrangement available on site. A rooftop or podium installation also has to satisfy the structural engineer for wet and dead loads, which is a conversation to open at concept stage, not after procurement.
Options that change the operating profile
The range is configurable, and the catalogue lists control systems, UV sterilisation, additional water pumps, heat pumps, sand filtration, insulation and steps as options. Each one answers a specific project question:
- Heat pump — determines whether the spa runs at a usable temperature through a cold season, and it is the main driver of running cost for year-round use.
- Insulation — matters most on exposed terraces and rooftops where wind chill pulls heat out of the shell overnight.
- UV sterilisation and sand filtration — reduce the chemical load and the cleaning cycle, which is what hotel operators care about when housekeeping, not an engineer, maintains the water day to day.
- Steps — decide how guests enter. A spa set into a deck needs moulded steps; a unit sitting on a slab may only need a single step or a surround.
The WS-130Aⅲ-U variant is listed in the same 8000 × 3000 × 1400 mm shell with a different jet and pump arrangement, so where the swim current is less important than the hydrotherapy seating, compare both rather than assuming one configuration covers both uses.
How the spa fits a wider furnishing package
A swim spa is rarely bought alone. On a resort or villa project it sits alongside poolside loungers, shade structures, outdoor dining sets and the wet-area finishes around it, and those items come from different suppliers with different lead times. Coordinating them as one package avoids the situation where the spa arrives before the deck, the power feed or the drainage is ready.
SANTERSON works as a one-stop furniture and building materials supplier, so the swim spa can be procured in the same package as the surrounding outdoor furniture, wall and ceiling finishes, lighting and interior fixtures. Our turnkey solutions cover design consultation and space planning, production, logistics with door-to-door delivery, installation support and after-sales service, which keeps a single accountable party across the whole scope.
That structure is already in use on Australian residential work. Published project cases include villas in Willoughby, North Turramurra, Sydney and Melbourne, plus a Perth housing project — each handled as a coordinated package rather than separate purchase orders. Project scope and drawings for those cases are available on request; we do not publish client details or performance figures.
A short pre-order checklist
- Confirm the clear floor envelope, access route for delivery, and the slab or deck build-up against the catalogue dimensions of the chosen model.
- Have the structural engineer sign off wet loads for any elevated installation before the spa is fixed in the drawing set.
- Agree the electrical supply, protection device and load with the building services team, using the confirmed specification rather than the standard catalogue figure alone.
- Decide drainage, plant location and maintenance access — service clearance behind the cabinet is where most late site changes occur.
- select the option set (heat pump, insulation, filtration, steps) against how the spa will actually be used and by whom it will be maintained.
- Sequence the spa with the surrounding outdoor furniture and finishes in one procurement schedule, so nothing lands before its substrate is ready.
Send us the drawings
Share the plan, elevation and available power for your terrace, rooftop or garden, and we will confirm which model in the swim spa range fits the envelope, what the option set should be, and how the unit is delivered and installed as part of the wider package. Contact SANTERSON to start.