A swim spa enquiry that arrives with a site photograph, an electrical note and a clear idea of how the spa will be used moves far faster than one that only carries a model number. If you are specifying Outdoor Swim Spa WS-S06 for a villa terrace, a resort garden or a private residence project, the information in your first message largely decides how quickly you receive a usable quotation and a delivery plan.
The list below follows the order our engineering and project teams work through an enquiry. Send what you already have; the gaps we fill together.
Start With How the Spa Will Be Used
Before any dimension is discussed, tell us who will use the spa and how often. A spa installed for daily training, a spa used mainly as a hydrotherapy seat for two people, and a spa specified as an amenity for a small hotel are configured differently even when they sit on the same slab.
- Primary purpose: exercise, hydrotherapy and relaxation, family use, or guest amenity.
- Typical occupancy: how many people should be comfortable in the water at one time.
- Usage pattern: daily year-round operation, seasonal use, or occasional use during events.
- Users to design for: children, older users with limited mobility, hotel guests with varying expectations.
- Adjacent outdoor furniture: if the spa sits within a wider terrace scheme, say whether pergolas, loungers or dining sets belong to the same order so finishes and layouts can be coordinated.
The Site Information That Shapes the Configuration
Outdoor swim spas are built to a fixed shell, but how they reach your site and settle into it is entirely project-specific. Four site questions come up on every WS-S06 enquiry.
1. Where the spa will sit
Tell us whether the spa is fully exposed, partly sheltered by a pergola or hardtop, set into a deck, or placed on a raised platform. A terrace on an apartment block and a ground-level garden in a coastal villa create different wind, drainage and privacy conditions, and those conditions feed into insulation choices and access steps.
2. Access route from the delivery vehicle
The catalog dimension for WS-S06 is 5820 × 2220 × 1110 mm, so the shell has to pass through gates, around corners and over any level change on its way to the final position. Send photographs of the access route, plus widths and heights of any gate, doorway or passage it must clear. Where a crane is needed or the route is tight, knowing this at quotation stage avoids an expensive surprise on delivery day.
3. Slab, deck and drainage
Share the planned supporting structure — concrete slab, reinforced timber deck or pedestal-supported platform — along with its dimensions, and confirm how surface water drains away from the shell. If your team has already produced a landscape or civil drawing, send it. If not, give us the intended position and we can advise on what the base needs to achieve.
4. Electrical supply at the spa location
The catalog lists total power for this configuration at 6.35 kW. Please send the supply available where the spa will stand: single-phase or three-phase, voltage, breaker capacity and the distance from the distribution board. Electrical requirements vary with the selected configuration, so this is confirmed against your final specification rather than assumed.
Which Features You Actually Want
The catalog entry for WS-S06 shows water jets, LED lighting, ozone sanitisation, a waterfall and four water columns. The captured specification also lists 56 jets in total, two water pumps, one filter pump, one control system, and two LED lights together with 18 small LED lights. A swim training system is not listed for this particular model. That last point matters: if counter-current swimming is a requirement rather than a nice-to-have, say so at the start, because models such as Outdoor Swim Spa WS-S06CT and other variants in the range carry a swim training system as a listed feature.
Catalog-listed options for this range include control systems, UV sterilisation, water pumps, heat pumps, sand filtration, insulation and steps. Tell us which of these you want included and which you plan to source locally. A heat pump and additional insulation change both the running profile and the electrical requirement, so they belong on the quotation rather than being added later.
A Reference Table You Can Fill In
Copy this into your enquiry. Leaving a line blank is fine — it simply becomes an item we confirm with you.
| Item | What to send |
|---|---|
| Model of interest | WS-S06, or the closest variant if your requirements point elsewhere |
| Quantity and location | Number of units; project address or city; single villa, multi-unit or hospitality development |
| Intended use | Exercise, hydrotherapy, family, guest amenity |
| Installation setting | Exposed terrace, sheltered garden, set into deck, indoor-adjacent |
| Access constraints | Gate and passage widths, level changes, crane need, photos of the route |
| Base condition | Slab or deck type and size; drainage arrangement; existing drawing if available |
| Electrical supply | Phase, voltage, breaker capacity, cable run distance |
| Options wanted | Heat pump, UV sterilisation, sand filtration, insulation grade, steps, cover |
| Water and drainage | Fill source; where the spa is drained and how waste water is routed |
| Programme | Desired site date; any milestone that cannot move |
| Budget range | Optional, but it helps us propose a realistic specification first |
| Other scope | Outdoor furniture, pergolas, lighting, wall panels or other finishes from the same project |
How the Enquiry Moves From Here
SANTERSON works as a manufacturer and one-stop supplier for furniture and building materials, with projects across villas, hospitality and offices. A swim spa enquiry follows the same route as our other project work: consultation, design and planning, production, logistics, installation and after-sales.
In practice that means an initial review of your site information, a recommended configuration with a quotation, confirmation of equipment and details before production starts, then shipping arranged through our logistics and door-to-door delivery service. Where the spa forms part of a wider fit-out, the same team coordinates it with the other elements on the order — see our turnkey solutions for how villa and hospitality projects are handled end to end.
If you are assembling a complete outdoor area rather than a single unit, browse the swimming pools and swim spas category alongside our outdoor collections so the spa, seating and shading are specified as one scheme.
Two things we confirm before production rather than assume: the exact equipment included in your chosen configuration, and the electrical requirement that follows from it. Catalog figures describe a standard build; your site conditions decide the final specification.
Questions Buyers Ask at This Stage
Can I order the spa on its own?
Yes. A single swim spa enquiry is handled by itself. Many project buyers combine it with the rest of the outdoor and interior scope, though, to avoid coordinating several suppliers on one programme.
What if my slab is not built yet?
Send the intended position and the planned construction. We advise on what the base must support before your contractor pours, which costs far less than correcting a slab afterwards.
Can the specification change after quotation?
It can, up to the point production starts. Changing jet count, pump arrangement or heating after that means re-quoting and a revised programme, so it is worth settling the water features early.
Who handles installation?
Installation and after-sales support form part of project delivery, with inspection and handover on site. The scope agreed for your project defines exactly what that covers, so ask for it in writing alongside the quotation.
Ready to Send Your Enquiry
The quickest route is a short message with your location, intended use, one photograph of the site and whatever electrical detail you already hold. From there we come back with a configuration recommendation for WS-S06 — or another model in the range if your requirements point that way — together with a quotation and a delivery plan.
Talk to our project team
Contact SANTERSON about Outdoor Swim Spa WS-S06, or a wider outdoor and interior package for your villa, resort or hospitality project. Phone and WhatsApp: +86-13928214007 (PHILLIP). Email: santerson@qq.com. Enquiry form: Contact Us.