Textured melamine cabinet fronts look simple on a sample board and far more complex once the whole run is installed in a real kitchen. Before an order is released, buyers should confirm the exact finish, panel dimensions and construction details in writing, so the cabinets that arrive match the cabinets that were approved. As a China furniture and building materials manufacturer, SANTERSON supplies made-to-measure cabinetry for residential and project work, and the checklist below follows the points our production team needs to finalize on every job.

1. The Exact Surface You Are Approving

“Textured” covers a wide field of surfaces: fine micro-texture, wood-grain embossing, and matte tactile films all read differently under kitchen lighting. A name on a specification sheet is not enough. Ask which specific surface from the textured melamine cabinets collection is being produced, and confirm the finish name, colour reference and texture direction against a physical sample before sign-off. Keep the approved sample itself; it is the reference the whole delivery is judged against.

Check the sample at an angle and under both warm and cool light. Texture that looks subtle on a small board can look prominent across a tall door, and grain direction changes how seams and adjacent panels read.

2. Edges and Panel Construction

Texture is only as good as the edge that closes it. Confirm the edge banding material and colour match, the edge thickness, and whether the edges are finished on all visible sides. On handleless or J-pull profiles, ask how the profile is formed and finished, because that detail is where a run either matches the sample or does not. Note the substrate and door construction being quoted, and keep the same specification for every batch on multi-unit jobs.

3. Dimensions, Tolerances and Site Conditions

Cabinet sizes should come from the actual site, not from a typical drawing. Our cabinets are made to measure, so final heights, depths and module widths must match the walls, appliances and services at the property. Confirm finished dimensions against the as-built drawings, who signed them, and how out-of-square walls or floor levels are handled. For a delivery spread across several apartments or villas, the same question applies unit by unit.

4. Hardware and Integration Details

Decide the hinges, drawer runners, handles or integrated pulls, and who supplies them. Specify the opening direction of each door, the position of integrated appliances, and how cut-outs for sinks, cooktops and ovens are dimensioned. Lighting inside cabinets and cable routing should also be fixed before production, because drilling and machining are done at the factory and cannot be corrected cheaply on site.

5. Consistency Across a Multi-Room or Multi-Unit Order

Kitchens rarely stand alone. Wardrobe and storage runs made in the same finish should be ordered together or referenced to the same approved batch, so texture and colour match across the building. The same surface language can continue through the textured melamine wardrobes collection, subject to the same sample approval. Where a project mixes finishes, for example a matte melamine carcass with textured feature doors, confirm each combination on one board rather than trusting two separate samples.

6. Documentation Before the Order Is Released

Before production starts, the purchase file should hold the approved sample reference, signed dimensional drawings, the hardware schedule, and a record of any agreed deviations. A single page listing finish codes, quantities per module and site conditions prevents most disputes later. After production, inspect panels against the retained sample at delivery, before installation begins, and record any variance then while it can still be corrected.

A Practical Way to Lock the Details Down

For project buyers, the most efficient route is to send drawings and finish requirements early and let the factory return a confirmed specification for review. SANTERSON works from design consultation and material selection through manufacturing and project coordination as part of its one-stop solution, so the finish questions above are answered before the order enters production rather than after panels reach site.

If you are specifying cabinets for a kitchen, wardrobe or multi-unit fit-out, start with the exact surface, the exact dimensions and a documented sign-off. Those three confirmations, done once, carry through the entire order.